Silicone Mold Washer
High-performance washing system for cleaning silicone molds with
integrated main wash, rinse and drying, for fast and effective cleaning
of medium to highly polluted silicone molds. It helps to achieve a
maximum washing results and with minimum water, energy, and chemical
consumption.
In the main washing zone, the silicone molds are cleaned with
circulating water, which is constantly cleaned by the built-in filter
system. The built-in heating tank keeps the washing water in the main
flushing zone at the desired temperature. In the rinse zone, the
silicone molds are rinsed clean with fresh water. This water is then fed
into the main washing zone with the “double cascade system” and it
continuously regenerates the washing water. After rinsing, the molds
pass through the drying zone and are blown dry via air nozzles at high
air volume. The blown-off water is also returned to the washing zone via
the cascade system.
The built-in special nozzles ensure a thorough cleaning of the
washing material. To ensure optimal cleaning, the silicone molds are
transported through the system by a stainless-steel chain strap lying at
the top and bottom. This allows different contaminated silicone molds
to be cleaned with the precisely matched amount of water.
Specifications
- Capacity: 100 – 2,000 molds per hour
- The silicone molds are set up and delivered manually by hand
- Complies with HACCP standards
Technical Data
- Stainless steel
- Total length: 6058mm
- Length without entry-outlet table: 3810mm
- Height: 1700mm
- Width: 1100/1300mm
- Inlet/outlet height: 970mm
- Inlet/outlet length: 500/1750mm
Options
- Drying module – Heating system with higher air blowers and uses electric energy
- Drying via centris - Pallet spinner to remove excess water with less energy consumption
- Water filtration
- Fume extraction exhaust system
- One-man operation
- With conveyor belts
- Dosing pump
Customizable per customers’ requirements
